Tasks to Be Done:
1.
Create the Diagram as shown above and Perform
the following as clarified Below:
a.
Provide the Hostnames (R1, S1 and S2 ) for
Routers and the Switches Respectively
b.
Provide the passwords as:
i.
Telnet Password : telpass
ii.
Console Password : compass
iii.
Privilege password : privpass
c.
Create the Banner on all the devices as :
**************************************
ADMINISTRATORS ONLY
**************************************
d.
Creates the VLAN’s as Shown on the diagram and
ensure you only create them on the VTP server switch only as illustrated on the
diagram.
e.
The IP address of the Computers on the
VLAN’s is as elaborated below, ensure the computers on the respective VLAN
receives the right IP address:
i.
TCICT105 = 192.168.1.0/27
ii.
TCICT106 = 192.168.1.32/27
f.
After doing that all, Please ensure all the
trunking is set between the switches and Routers and verify if it is applied.
g.
Set S1 as the VTP server Mode and the
other switches as the VTP Client mode and please verify.
h.
Create a VTP Domain of setup.net
i.
Please verify the VTP information is well
configured as instructed and proceed
2.
After all this is done please ensure all the
machines in the same VLAN are communicating but not on the different VLAN
before proceeding.
3.
After doing that ensure the Inter-VLAN
communication is performed and computers in both VLAN’s can communicate.
4.
After all this enable service password
encryption in all your Configuration files and save them awaiting for
Submission.
-
No comments:
Post a Comment